Wave power generation

Exhibition Name: Wave Energy

1、 Basic information

1. Schematic diagram of the appearance of exhibits

2. Introduction to Exhibits

Exhibitions are located in the Energy and Environment exhibition area of the Life Technology Exhibition Hall. They consist of a wave energy generation device consisting of a piston with a handle (marked 1), a coil (marked 2), a magnet (marked 3), an LED light bulb (marked 4), a float (marked 5), a water tank (marked 6), and other components. The audience drives the piston to move by operating the handle, creating waves and causing the three floats in the water tank to move up and down. This drives the magnet connected to the floats to move up and down in the coil, generating electricity and lighting up the LED bulb next to them.

3. Display purpose

Exhibition items showcase the working principle of mechanical wave energy generation to the audience through interactive physical models.

4. Exhibition knowledge points

Wave energy generation is the production of electrical energy powered by the energy of waves. There are thousands of power generation methods, which are mainly divided into three categories based on the intermediate energy conversion process: mechanical, pneumatic, and hydraulic. Mechanical power generation is the process of converting the kinetic energy of wave energy into electrical energy through a mechanical transmission mechanism. Exhibitions convert the reciprocating motion of waves into the up and down motion of a float, which drives the magnet to move up and down in the coil, cutting the magnetic induction line and generating induced current.

5. Exhibition operation process

6. Notes

1) Handle design limit device;

2) All materials and parts must be made of waterproof and anti rust materials, such as stainless steel, ABS, etc;

3) Transparent acrylic requires anti fogging treatment.

7. Reference dimensions for the appearance of exhibits (unit: meter)

long

wide

tall

Overall dimensions

3.4

0.6

1.1

8. Composition of exhibitions

1) Main Material List

Main component names

Main materials

Processing Technology

Water tank base

30 # stainless steel square tube+3mm stainless steel plate

Surface baking finish

water tank

20mm high transparency organic glass

/

Float, piston

foam plastic

/

handle

High hardness plastic

/

2) Main equipment list

name

Specification

quantity

LED bulb

/

3 of them

coil

/

3 groups

magnet

/

3 pieces

2、 Exhibition operation management

1. Daily management

Open all day, no need for dedicated personnel to guard, inspection is required.

2. Maintenance and Repair

1) The maintenance door is set up reasonably, and the exhibited equipment and components can be disassembled and inspected from the front.

2) The water tank is easy to replace with water and has dedicated water supply and drainage interfaces.

3) The water inlet needs to have a water purification device.

3、 Construction conditions

1. Environmental requirements

Category

requirement

floor load-bearing capacity

≥ 3500N/ ㎡

power consumption

Nothing

Do you need water supply and drainage

□ Water supply □ Drainage R Water supply and drainage

Do you need to connect to the network

□ Yes R No

Environmental light demand

Normal

video demonstration