shoot with unfailing accuracy
- In stock with stable lead times — single units or complete sets
- Size, appearance and interaction can be adapted to the museum’s theme
- For science museums, campus science rooms, community science centers and mobile science museums
- Export packing and overseas on-site installation support
Hefei Science Museum Innovation Exhibits Deepening Design and Production Service Project Exhibition 3- One Hundred Blows, One Hundred Strikes
Exhibition size: approximately 2.42 × 1.0 × 1 5 meters (length x depth x height)
Knowledge points:
An object is thrown out horizontally at a certain initial velocity. If the object is only subjected to gravity, this motion is called flat throwing motion. An object in a flat throwing motion moves in a uniformly variable speed curve due to the constant force acting on it. The trajectory of the flat throwing object is a parabola. Flat throwing motion can be regarded as the combined motion of the following two motions: (1) an object moves in a uniform straight line with a constant initial velocity due to inertia, without being subjected to external forces in the horizontal direction; (2) The free fall motion of an object with zero initial velocity in the vertical direction, which is only affected by gravity. These two sub movements are independent of each other and occur simultaneously, possessing the independence and simultaneity of sub movements.
Participation method:
On the left side of the exhibition items is a section of inclined rail, with a limited slot and release device at the initial position above the inclined rail. The end of the inclined rail is a straight rail. There is a photoelectric switch at the end of the straight track. On the right side of the exhibition items is a set of brackets, with circular rings installed on the brackets in sequence, with an initial height consistent with the straight rail. There is a parabolic curve depicted on the back panel of the bracket, and there is an electrochromic glass cover in front of the back panel. The audience places the ball at the initial position above the inclined track and releases it. When the ball rolls to the end of the straight track, it triggers the photoelectric switch and continues to perform a flat throwing motion forward. The triggered photoelectric switch controls the solenoid valve to instantly release the ring, causing the ring and the flat throwing ball to fall simultaneously. The ball always smoothly passes through all the rings to reach the finish line. The audience presses the button, and the electrochromic glass becomes transparent, revealing a curve depicted on the back panel. Release the ball again and observe that the trajectory of the ball coincides with the curve depicted on the backboard.
Design and process requirements:
Exhibitions consist of inclined rails, straight rails, a set of circular rings, brackets, small balls, acrylic shields, electrochromic glass, backplates, photoelectric sensors, solenoid valves, etc. The circular rings are sequentially installed on the bracket, with an initial height consistent with the straight rail. The initial position above the inclined rail has a limited slot and release device. The end of the inclined rail is a straight rail. At the end of the straight track, there is a photoelectric switch that detects the passing of the ball and immediately releases the circular ring through the solenoid valve to fall freely. After the ball reaches the finish line, it can be picked up by the audience and returned to its initial position. The circular ring can be manually sent up by the audience and attracted by an electromagnet.
The exhibition items table body is made of Q235 sheet metal and the surface is treated with automotive paint. The track is smooth, with low friction, and the material is sturdy and durable. The bracket is made of stainless steel, which is corrosion-resistant and rust proof; The protective cover on the parabolic trajectory is made of transparent material, with no burrs or scratches on the surface, and is stable and durable. The circular ring and ball drop area below the exhibition items are designed with buffering and collection to avoid making loud noise when falling, and to prevent deformation or loss of the circular ring and ball due to falling.
Exhibition items must be designed reasonably, with excellent workmanship, to ensure the presentation effect.
Other requirements:
Also create related educational activity props, such as the "Dual Track Flat Throwing Exercise Experimenter". The prop must be able to be conveniently installed on the exhibition items booth during educational activities, and the power supply design should be reasonable.





